4. Using a Network Simulator (e.g. packet tracer) configure

a. Static Routing


Configure Static Routing is the routing that network administrator configures the network routers manually, instead of using routing protocols RIP, OSPF, etc. which utilized in the dynamic routing. The benefits of static routing are minimum bandwidth usage, no overhead on router CPU and much more and perfect for a small network with a few routers. But it is not without cons. It ‘s hard to configure all routers manually in the vast network and troubleshooting is always harder than configuration.

Configure Static Routing Using Cisco Packet Tracer

To perform this task, you must create your lab and configure the basic IP addressing for all PCs and Routers .

These are two videos that will help you to Configure Static Routing
I have configured the Static Route the same as the screenshot, and it is not yet configured routing. You must configure it with below step by step Static Routing guide.
Static Routing command syntax: Ip route [destination network address] [mask] [next hop address or interface name]
1. In the R1 type the following commands to introduce two LANs 192.168.10.0/24 and 192.168.30.0/24 for Router 1.
R1(config)#ip route 192.168.30.0 255.255.255.0 10.10.20.2 150
R1(config)#ip route 192.168.10.0 255.255.255.0 10.10.10.2 150
2. Router2: Add three networks for router 2 and be sure that do not configure it with wrong IP address.
R2(config)#ip route 192.168.10.0 255.255.255.0 10.10.10.1 150
R2(config)#ip route 10.10.10.0 255.255.255.0 10.10.20.1 150
R2(config)#ip route 192.168.20.0 255.255.255.0 10.10.20.1 150
3. Router3: Do the same as router 2 but with different destination and exit interface address.
R3(config)#ip route 192.168.30.0 255.255.255.0 10.10.20.1 150
R3(config)#ip route 10.10.20.0 255.255.255.0 10.10.10.1 150
R3(config)#ip route 192.168.20.0 255.255.255.0 10.10.10.1 150
So it’s easy and not too much difficult. If you want to accomplish this task, firstly you must try to understand the concept of routing and then try to configure it.